RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Blend Radius UR robots
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Blend Radius UR robots

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Blend Radius UR robots
Jeremy Offline
Moderator
*****
Posts: 1,832
Threads: 2
Joined: Oct 2018
Reputation: 70
#6
08-21-2019, 02:45 PM
Hi there,

Currently, the UR post processor only output blending value with three decimals.
So theoretically, the minimum Blending radius is 1 mm.

你can always modify the behavior of the UR post processor by editing it for your needs.
The "blend_radius_check" function is where you should apply your modifications.
Note that we do not guarantee that it will work properly on the robot with smaller values.

Have a great day.
Jeremy
Find
Reply


Messages In This Thread
Blend Radius UR robots - byMitja GOLOB- 07-24-2019, 05:52 AM
RE: Blend Radius UR robots - byJeremy- 07-24-2019, 07:32 PM
RE: Blend Radius UR robots - byMitja GOLOB- 08-21-2019, 06:12 AM
RE: Blend Radius UR robots - byAlbert- 08-21-2019, 11:27 AM
RE: Blend Radius UR robots - byMitja GOLOB- 08-21-2019, 01:47 PM
RE: Blend Radius UR robots - byJeremy- 08-21-2019, 02:45 PM
RE: Blend Radius UR robots - bybeaphickman- 11-07-2022, 02:47 PM
RE: Blend Radius UR robots - byJeremy- 11-08-2022, 06:04 PM



Users browsing this thread:
1 Guest(s)