RoboDK Forum> RoboDK (EN)> General questions about RoboDK> ABB IRC5 - Problem with I/O
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> ABB IRC5 - Problem with I/O

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
ABB IRC5 - Problem with I/O
Nox Offline
Member
**
Posts: 43
Threads: 19
Joined: Jun 2018
Reputation: 2
#3
07-02-2019, 06:35 AM
I've managed to connect and control the I/O from the IRC5 Controller, but the problem is that when I try to use them with RoboDK the controller doesn't do anything, mainly because the driver file that you provide is not doing anything in that piece of code, like I said, the code is commented, and if I uncomment those lines, the controller prompts an error.
Find
Reply


Messages In This Thread
ABB IRC5 - Problem with I/O - byNox- 06-30-2019, 10:15 AM
再保险:ABB红外C5 - Problem with I/O - byNox- 07-02-2019, 06:35 AM
再保险:ABB红外C5 - Problem with I/O - byNox- 07-03-2019, 02:42 AM
再保险:ABB红外C5 - Problem with I/O - byNox- 07-03-2019, 07:02 AM
再保险:ABB红外C5 - Problem with I/O - byNox- 07-03-2019, 11:57 PM
再保险:ABB红外C5 - Problem with I/O - byNox- 07-04-2019, 03:14 AM
再保险:ABB红外C5 - Problem with I/O - byAlbert- 07-04-2019,上午10:10
再保险:ABB红外C5 - Problem with I/O - byNox- 07-05-2019, 08:35 AM



Users browsing this thread:
1 Guest(s)