RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Set I/O did not work on UR3e
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Set I/O did not work on UR3e

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Set I/O did not work on UR3e
wiww Offline
Junior Member
*
Posts: 5
Threads: 2
加入:2023年7月
Reputation: 0
#3
07-26-2023, 01:43 PM
(07-26-2023, 09:05 AM)Albert Wrote:I noticed you have a timeout for 5 seconds. Can you try removing this timeout?

Can you also share the log messages on the teach pendant and in RoboDK?

Thanks for your reply!!! I removed the timeout but it didnot change anything. Here are the log files on RoboDK and UR teach pandent. I looked through the log on RoboDk, there was a warning said using old controller compatibility. Is it this fault? How to solve that?


Attached Files Thumbnail(s)

Find
Reply


Messages In This Thread
Set I/O did not work on UR3e - bywiww- 07-26-2023, 08:46 AM
RE: Set I/O did not work on UR3e - byAlbert- 07-26-2023, 09:05 AM
RE: Set I/O did not work on UR3e - bywiww- 07-26-2023, 01:43 PM
RE: Set I/O did not work on UR3e - byAlbert- 07-26-2023, 07:15 PM
RE: Set I/O did not work on UR3e - bywiww- 07-27-2023, 07:52 AM
RE: Set I/O did not work on UR3e - byAlbert- 07-27-2023, 08:29 AM



Users browsing this thread:
1 Guest(s)