RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Failed to generate program using the Mitsubishi Post Processor
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Failed to generate program using the Mitsubishi Post Processor

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Failed to generate program using the Mitsubishi Post Processor
Wolf Offline
Junior Member
*
Posts: 6
Threads: 0
Joined: May 2023
Reputation: 0
#6
05-28-2023, 05:27 PM
I tried both the version from Albert which also leads to the RobotCom error and from Sergei which unfortunately leads again to the lower caser error from the original post. I switched to python 37 to get a smiliar setup.

Any hints what I might do wrong?

Thanks in advance
Find
Reply


Messages In This Thread
RE: Faliled to generate prog "Prog1" using the Post Processor "Mitsubishi" - byWolf- 05-28-2023, 05:27 PM



Users browsing this thread:
1 Guest(s)