04-01-2023, 04:33 AM
Hi everybody
Recently we try to operate iuka robot with a turn table for milling so after getting throw all the videos and the documentation available in the enternet i manag to add my setup in robodk environment
I chose to work with bobcadcam for the toolpath generation but after loading the part and the toolpath to robo dk nothing worked as i expected everything becomes in red (coll..unreachable...) besides the long time robodk take for processing the milling cod that bobcamcam generat
I'm stuck in this piont i don't know how to minimize the time to process my milling
Is it possible if i change my cam software i could find better results
Recently we try to operate iuka robot with a turn table for milling so after getting throw all the videos and the documentation available in the enternet i manag to add my setup in robodk environment
I chose to work with bobcadcam for the toolpath generation but after loading the part and the toolpath to robo dk nothing worked as i expected everything becomes in red (coll..unreachable...) besides the long time robodk take for processing the milling cod that bobcamcam generat
I'm stuck in this piont i don't know how to minimize the time to process my milling
Is it possible if i change my cam software i could find better results