RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Questions on post-process and how to import joint coordinates
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Questions on post-process and how to import joint coordinates

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Questions on post-process and how to import joint coordinates
Steve Zhang Offline
Member
**
Posts: 17
Threads: 6
Joined: Aug 2022
Reputation: 0
#3
03-24-2023, 01:10 PM
(03-24-2023, 09:43 AM)Albert Wrote:Yes, this is possible. It should not be complicated to do so using the API.

The following scripts will help you manipulate data to read and write CSV files from your simulation in RoboDK:
ProgramSlider.py
ImportCSV_XYZWPR.py

You can find these scripts here:
C:/RoboDK/Library/Scripts/

OK,thanks a lot.
By the way,i'd like to ask again about Q2...
If I only have the joint value,how should I arrange them in CSV file? is it possible for Synchronize external axes？
I want to load the joint data from a CSV file into the RoboDK and run the simulation...not get data from simulation...


Attached Files Thumbnail(s)

Find
Reply


Messages In This Thread
RE: Questions on post-process and how to import joint coordinates - bySteve Zhang- 03-24-2023, 01:10点



Users browsing this thread:
1 Guest(s)