RoboDK Forum> RoboDK (EN)> Request new features> driver and a post processor of Dobot-Arm MG400
RoboDK Forum> RoboDK (EN)> Request new features> driver and a post processor of Dobot-Arm MG400

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

driver and a post processor of Dobot-Arm MG400
Albert Offline
Moderator
*****
Posts: 2,329
Threads: 2
Joined: Apr 2018
Reputation: 125
#5
03-20-2023, 09:59 AM (This post was last modified: 03-20-2023, 09:59 AM byAlbert.)
I noticed there was an issue when generating joint moves. You should provide joint values, not the pose. I attached the post processor with some minor edits.


Attached Files
.py Dobot_MG400.py(Size: 21.67 KB / Downloads: 88)
Find
Reply


Messages In This Thread
RE: driver and a post processor of Dobot-Arm MG400 - byAlbert- 03-20-2023, 09:59 AM



Users browsing this thread:
1 Guest(s)