[mikerhodes]

Hi RoboDK Team,

Such a dream to work with your software, worth every penny!

Question.

I have a seventh axis table that I have not started using, but am milling perfect 3 Axis jobs when the table is set to home. When I rotate the table 180' to work on another piece of stone, my cell wants to revert back to its "home" position. Should I use Codium to redo the E1 degree variable? Is there a way I can modify the KRC4 post-processor to ignore the E1 coordinates for now?

我试图得到3轴铣削掌握I even begin to start 5 axis with RDK.

I have rotated the table 180' from its home position, and I would like it to stay like that so I can mill the next job.

Any ideas?

Secondly,

I have encountered the classic error of "start point is equal to end point" with the robot milling letters. This seems to be an issue with the CIRC motion, but I have corrected some of the issues changing the min step and max step in the options of RoboDk. Is there a better solution to solve this in CAM before RoboDK even posts the project?

Any ideas?

Thank you Gentlemen for your support,

Mike Rhodes