help with Kuka calibration

Albert Offline

Moderator

Posts: 2,413
Threads: 2
Joined: Apr 2018
Reputation: 132

02-28-2023, 11:05 AM

The TOOL and BASE that is used when you load the program is exactly the same in both scenarios (with the dollar sign and without). The warning message you see is because RoboDK does not know the definition of the TOOL and BASE with the index. Therefore, the currently active tool and reference frames are used.

Find

Messages In This Thread

help with Kuka calibration - byKarl- 01-02-2023, 10:36 PM

RE: help with Kuka calibration - byAlbert- 01-05-2023, 09:46 AM

RE: help with Kuka calibration - byKarl- 01-05-2023, 04:23 PM

RE: help with Kuka calibration - byKarl- 01-05-2023, 10:59 PM

RE: help with Kuka calibration - bySergei- 01-06-2023, 10:49 AM

RE: help with Kuka calibration - byKarl- 01-06-2023, 06:05 PM

RE: help with Kuka calibration - byAlbert- 01-09-2023, 11:20 AM

RE: help with Kuka calibration - byKarl- 02-24-2023, 06:05 PM

RE: help with Kuka calibration - byKarl- 04-16-2023, 03:07 PM

RE: help with Kuka calibration - byAlbert- 02-28-2023, 11:05 AM

RE: help with Kuka calibration - byAlbert- 04-16-2023, 06:38点

RE: help with Kuka calibration - byKarl- 08-10-2023, 12:30 PM

RE: help with Kuka calibration - byAlbert- 08-10-2023, 04:11 PM

RE: help with Kuka calibration - byKarl- 08-11-2023, 02:11 PM

Users browsing this thread:

1 Guest(s)