02-19-2023, 05:35 AM
Hi RoboDK Team,
In order to run machining projects over 3000 lines of machining code with a KUKA KR120 R 2700 Extra HA,
Do I need to purchase CamRob or Kuka CNC to automatically run a sculpting job on stone? I successfully optimized a job I needed to complete in under 3K lines of code, but is there a way to stream code from RoboDK directly to a Kuka KRC4 in RoboDK?
If not, Perfectly understood.
Recommendation on best tech pack from Kuka for this? RoboDk is exceptional on so many levels, but I need some guidance on what the best avenue is to perform 100 000 lines of code minimum.
Is there a prefix I can employ in my code from RoboDK to automatically run the next cycle?
Mike Rhodes,
Thank you!
In order to run machining projects over 3000 lines of machining code with a KUKA KR120 R 2700 Extra HA,
Do I need to purchase CamRob or Kuka CNC to automatically run a sculpting job on stone? I successfully optimized a job I needed to complete in under 3K lines of code, but is there a way to stream code from RoboDK directly to a Kuka KRC4 in RoboDK?
If not, Perfectly understood.
Recommendation on best tech pack from Kuka for this? RoboDk is exceptional on so many levels, but I need some guidance on what the best avenue is to perform 100 000 lines of code minimum.
Is there a prefix I can employ in my code from RoboDK to automatically run the next cycle?
Mike Rhodes,
Thank you!