02-02-2023, 12:40 AM
Understood, I will do this again tomorrow. I have also modelled our table and now have attached an accurate model of my spindle down to the mm. Base E1 is the base I setup today. I will do my best to give you ALL of the information I can as well as a new cell model. I will make sure you have more information to work with.
Thank you so kindly for being patient with me, I know you are a very busy man. For anyone reading this thread, please understand this has NOTHING to do with the ability of RoboDK, this is a new programmer having growing pains. Learning takes work and you cannot expect everyone to do all the work you. RoboDK has really backed up their users!
Thank you so much again Albert,
I will make sure you have the information tomorrow.
Mike Rhodes
Thank you so kindly for being patient with me, I know you are a very busy man. For anyone reading this thread, please understand this has NOTHING to do with the ability of RoboDK, this is a new programmer having growing pains. Learning takes work and you cannot expect everyone to do all the work you. RoboDK has really backed up their users!
Thank you so much again Albert,
I will make sure you have the information tomorrow.
Mike Rhodes