Setting robot start point on a milling project

Albert

Moderator

Posts: 2,342
Threads: 2
Joined: Apr 2018
Reputation: 127

01-26-2023, 05:49 PM

我忘了附上RDK项目文件cell included (IGES file). I split the table and the layout. I'm not sure if this represents your real setup. I don't think so because the part is on the floor. Can you confirm?

Attached Files
.rdk

KUKA KR120-v2.rdk(Size: 1.03 MB / Downloads: 81)

Find

Messages In This Thread

Setting robot start point on a milling project - bymikerhodes- 01-25-2023, 02:46 AM

RE: Setting robot start point on a milling project - byAlbert- 01-25-2023, 07:32 AM

RE: Setting robot start point on a milling project - bymikerhodes- 01-25-2023, 02:57 PM

RE: Setting robot start point on a milling project - bymikerhodes- 01-25-2023, 07:15 PM

RE: Setting robot start point on a milling project - byAlbert- 01-26-2023, 05:40 PM

RE: Setting robot start point on a milling project - byAlbert- 01-26-2023, 05:49 PM

RE: Setting robot start point on a milling project - bymikerhodes- 01-26-2023, 07:12 PM

RE: Setting robot start point on a milling project - bymikerhodes- 01-26-2023, 11:11 PM

RE: Setting robot start point on a milling project - bySergei- 01-27-2023, 05:41 PM

RE: Setting robot start point on a milling project - bymikerhodes- 01-27-2023, 08:08 PM

RE: Setting robot start point on a milling project - byAlbert- 01-30-2023, 11:51 AM

RE: Setting robot start point on a milling project - bymikerhodes- 02-01-2023, 05:35 PM

RE: Setting robot start point on a milling project - byAlbert- 02-01-2023, 08:49 PM

RE: Setting robot start point on a milling project - bymikerhodes- 02-02-2023, 12:40 AM

RE: Setting robot start point on a milling project - bymikerhodes- 02-19-2023, 05:26 AM

Users browsing this thread:

1 Guest(s)