12-01-2022, 02:50 PM
Hi ?
我们目前有年代ome issues concerning the post processor for an abb s4c+ Controller. The robodk s4c postprocessor now generates
SetDO D_OUT_3 when we load the program the controller want is to change it to DO_03
We have run the program and did a manual replacement of the SetDO D_OUT_3 to DO_03 in visual studio code an that works.
We looked at the base post, but need to go deeper in the post. Obviously we want the postprocessor to do the correction how can we approach the issue here. Can someone elaborate on this!
Regards de besturing
我们目前有年代ome issues concerning the post processor for an abb s4c+ Controller. The robodk s4c postprocessor now generates
SetDO D_OUT_3 when we load the program the controller want is to change it to DO_03
We have run the program and did a manual replacement of the SetDO D_OUT_3 to DO_03 in visual studio code an that works.
We looked at the base post, but need to go deeper in the post. Obviously we want the postprocessor to do the correction how can we approach the issue here. Can someone elaborate on this!
Regards de besturing