09-09-2022, 07:14 PM
插件的发明者——问题
When using "Auto" it only brings in to RoboDK the path, Not the whole object nor does it set it a curve follow project.
If you use the Load part, it does bring it in Fine.
But same when using Loading Points or curves, fails to bring the rest with it.
Note- using Inventor 2022
When using "Auto" it only brings in to RoboDK the path, Not the whole object nor does it set it a curve follow project.
If you use the Load part, it does bring it in Fine.
But same when using Loading Points or curves, fails to bring the rest with it.
Note- using Inventor 2022