(08-10-2022, 01:03 PM)Olivier Wrote:When the robot is back into the picking position after placing the first roller, the next part is sometimes already to far on the conveyor to be detected.
To fix this, open the python script "WaitForPart" and put a higher value in "TOLERANCE_CHECK_MM".
Thank you for the quick response. After increasing the Tolerance_Check_MM, I could run the simulation without any issue until the simulation speed is 1.4.But when I increase the simulation speed beyond that then the issue starts to reoccur.
Kindly advice on whether for simulating the conveyor logic "WaitForPart" we need to run at particular speed.