RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Staubli VAL3 Postprocessor
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Staubli VAL3 Postprocessor

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Staubli VAL3 Postprocessor
mzacri Offline
Junior Member
*
Posts: 6
Threads: 3
Joined: Jul 2022
Reputation: 0
#3
08-04-2022, 08:57 (This post was last modified: 08-04-2022, 08:59 AM bymzacri.)
(08-02-2022, 03:35 PM)mzacri Wrote:Hi,

The Staubli's VAL3 postprocessor generate code in the s7.X.X version of VAL3. Is there a way to downgrade this version to s5.5 since this is the newest version i can use on my CS8 controller?

Thanks!

Thanks a lot. I suppose because of the version mismatch, i was able to connect to robot, get its current position but i was not able to move it from RobotDK.
Find
Reply


Messages In This Thread
Staubli VAL3 Postprocessor - bymzacri- 08-02-2022, 03:35 PM
再保险:史陶比尔VAL3 Postprocessor - bySam- 08-03-2022, 12:15 PM
再保险:史陶比尔VAL3 Postprocessor - bymzacri- 08-04-2022, 08:57 AM



Users browsing this thread:
1 Guest(s)