07-18-2022, 08:59 PM
Hello,
I followed the procedure outlined inthis documentation. The whole procedure was very easy to follow and I didn't run into any issues. I started RDK_S3.pc on my FANUC R-30iB Plus controller then I booted up RoboDK on my computer and connected the computer to the c ontroller via RoboDK. A connection was established and it said "Ready" in the connection status bar. I then tried to click on "Get Position" and my control ended the RDK_S3.pc program and threw the error:
RDK_S3 LINE 551 PAUSED
INTP-311 (RDK_S3, 551) Uninitialized data is used.
我再次尝试,这time selecting the "Run on robot" and "Run" options, and those too raised the same error codes. Unfortunately, it looks like a .pc program is compiled code, so I can't see what line 551 is. Does anyone have a solution to this problem?
Thank you,
-RoboSmith
I followed the procedure outlined inthis documentation. The whole procedure was very easy to follow and I didn't run into any issues. I started RDK_S3.pc on my FANUC R-30iB Plus controller then I booted up RoboDK on my computer and connected the computer to the c ontroller via RoboDK. A connection was established and it said "Ready" in the connection status bar. I then tried to click on "Get Position" and my control ended the RDK_S3.pc program and threw the error:
RDK_S3 LINE 551 PAUSED
INTP-311 (RDK_S3, 551) Uninitialized data is used.
我再次尝试,这time selecting the "Run on robot" and "Run" options, and those too raised the same error codes. Unfortunately, it looks like a .pc program is compiled code, so I can't see what line 551 is. Does anyone have a solution to this problem?
Thank you,
-RoboSmith