RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Workspace display settings
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Workspace display settings

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Workspace display settings
Spencer Offline
Junior Member
*
Posts: 1
Threads: 1
Joined: Jun 2022
Reputation: 0
#1
06-20-2022, 08:21 PM (This post was last modified: 06-20-2022, 08:29 PM bySpencer.Edit Reason: New attachment of screenshot )
Are there any settings for the workspace and how it is displayed around the robot? I have a Kuka KR 120 R3200 PA robot that I have inserted into a model. When I go to turn on the workspace. I set it to Show for Robot Flange, but I only small gray sphere's all around the robot at the places where the lines would normally show up . Are there any settings to allow it to show the full robot reference grid?

Thanks,
Isaac Spencer


Attached Files Thumbnail(s)


.robot KUKA-KR-180-2-PA.robot(Size: 968.61 KB / Downloads: 124)
Find
Reply


Messages In This Thread
Workspace display settings - bySpencer——06-20-2022 08:21点
RE: Workspace display settings - byAlbert——07-03-2022, 06:45 PM



Users browsing this thread:
1 Guest(s)