Hello, please, how can I put there easily ArcOn and ArcOff? Extruder just marking volume of extruded filament...but when I want to use it for WAAM, I just want to put i there informations ArcOn and ArcOff. How it is possible?
Thanks.
Kind regards.
Tomas
I was meaning the start and the end of every path, that should be printed (every layer, infill, overlap etc.). I know, that for printing of plastics, there is information about volume of printed plastics, but I want to give the information to robot about ArcStart (start extruding) and ArcOff (stop extruding).
Thanks a lot.
Thanks.
Kind regards.
Tomas
I was meaning the start and the end of every path, that should be printed (every layer, infill, overlap etc.). I know, that for printing of plastics, there is information about volume of printed plastics, but I want to give the information to robot about ArcStart (start extruding) and ArcOff (stop extruding).
Thanks a lot.