Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Optimize CFP path

#4
Not related to the issue, but just curious. Your Spindle assy appears to be attached to the EOAT only with a clamping block. Aren't you concerned about it getting loose and losing position? Might be best to add a keyway to the block and shaft.


Messages In This Thread
Optimize CFP path - byr0b0tb0- 04-02-2022, 08:15 PM
RE: Optimize CFP path - byJeremy- 04-04-2022, 06:06 PM
RE: Optimize CFP path - byr0b0tb0- 04-05-2022, 01:37 PM
RE: Optimize CFP path - byWattUp- 04-05-2022, 03:02 PM
RE: Optimize CFP path - byr0b0tb0- 04-05-2022, 04:25 PM
RE: Optimize CFP path - byJeremy- 04-07-2022, 04:56 PM
RE: Optimize CFP path - byr0b0tb0- 04-07-2022, 07:31 PM
RE: Optimize CFP path - byJeremy- 04-19-2022, 08:59点



Users browsing this thread:
1 Guest(s)