04-03-2019, 09:58 AM
Hi All,
When I load a geometry from rhino to RoboDK, the loaded shape become out of scale. Is there a way to calibrate the units in Rhino and RoboDK? Also, I was wondering if there is an end-effector for concrete extrusion can be installed on RoboDK.
Thank you,
When I load a geometry from rhino to RoboDK, the loaded shape become out of scale. Is there a way to calibrate the units in Rhino and RoboDK? Also, I was wondering if there is an end-effector for concrete extrusion can be installed on RoboDK.
Thank you,