03-27-2019, 01:13 PM
Thanks for the help Jeremy, Your assistance was very helpful.
Now my next question is.
Once I have created the program in ROBODK and everything looks good, I output the program and upload to the UR. The joints do not operate as shown on my screen in the ROBODK, It still goes to my points, just in different configuration. What have I done or not done to cause this?
Now my next question is.
Once I have created the program in ROBODK and everything looks good, I output the program and upload to the UR. The joints do not operate as shown on my screen in the ROBODK, It still goes to my points, just in different configuration. What have I done or not done to cause this?