02-21-2022, 10:12 AM
(This post was last modified: 02-21-2022, 10:17 AM byAleix Ripoll.)
Hello,
I read several information about real robot connection in the forum. But is it possible to make a connection between RoboDK and an ABB virtual controller?
In my ABB virtual controller PC Interface option is activated and the IP address of the controller is 192.168.125.1
I have attached pack&go and robodk station to check it. An error message also appears in the abb teach pendant: "Socket error - the specified address is invalid. The only valid addresses are the LAN address of the controller or the service port address, 192.168.125.1"
here the attachments
I read several information about real robot connection in the forum. But is it possible to make a connection between RoboDK and an ABB virtual controller?
In my ABB virtual controller PC Interface option is activated and the IP address of the controller is 192.168.125.1
I have attached pack&go and robodk station to check it. An error message also appears in the abb teach pendant: "Socket error - the specified address is invalid. The only valid addresses are the LAN address of the controller or the service port address, 192.168.125.1"
here the attachments