RoboDK Forum> RoboDK (EN)> General questions about RoboDK> 川崎MX420L的工作范围
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> 川崎MX420L的工作范围

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

川崎MX420L的工作范围
Hiroe Offline
Member
**
Posts: 45
Threads: 24
Joined: May 2021
Reputation: 1
#6
02-16-2022, 06:17 AM
Dear Jeremy,

琼ry, my explanation was unclear.
The motion range of Joint 3 should be “+20 - −125”, according to the Kawasaki website.
The MX420L on RoboDK library is not defined in the range of motion, which allows the arm to interfere with the robot.



Best Regards,
Hiroe Ota
Find
Reply


Messages In This Thread
川崎MX420L的工作范围 - byHiroe- 02-14-2022, 02:13 PM
RE: Working range of Kawasaki MX420L - byJeremy- 02-14-2022, 09:57 PM
RE: Working range of Kawasaki MX420L - byHiroe- 02-14-2022, 11:28 PM
RE: Working range of Kawasaki MX420L - byAlbert- 02-15-2022, 11:22 AM
RE: Working range of Kawasaki MX420L - byJeremy- 02-15-2022, 12:24 PM
RE: Working range of Kawasaki MX420L - byHiroe- 02-16-2022, 06:17 AM
RE: Working range of Kawasaki MX420L - byJeremy- 02-16-2022, 01:17 PM
RE: Working range of Kawasaki MX420L - byOlivier- 02-16-2022, 06:51 PM
RE: Working range of Kawasaki MX420L - byHiroe- 02-17-2022, 01:59 PM



Users browsing this thread:
1 Guest(s)