01-26-2022, 01:08 AM
Hi Jeremy,
I keep having problems with RoboDK crashing when the error mentioned above occures:
Movement at instruction RhinoProject:MoveJ 1 is not possible.
Description: The target is too close to the axis limits.
In my cell I have added (via the Rhino add-in):
1x a Rhino"Project" Settings (via the "Auto Setup" button in Rhino)
3 x犀牛“啪rt" Settings (via the "Load Curve(s) button in Rhino)
Two problems:
a. In simulation all Curve Following Project Settings succeed but when I run the associated program only 2 work fine, the othe two will make RDK crash with the error above.
b. Running one of the four programs will often start one of the other Curve Following contours and not the associated one (according to the Settings).
My customer might not like it if I put the project public here. Is there a way I can send it to you?
Best regards,
Emile
I keep having problems with RoboDK crashing when the error mentioned above occures:
Movement at instruction RhinoProject:MoveJ 1 is not possible.
Description: The target is too close to the axis limits.
In my cell I have added (via the Rhino add-in):
1x a Rhino"Project" Settings (via the "Auto Setup" button in Rhino)
3 x犀牛“啪rt" Settings (via the "Load Curve(s) button in Rhino)
Two problems:
a. In simulation all Curve Following Project Settings succeed but when I run the associated program only 2 work fine, the othe two will make RDK crash with the error above.
b. Running one of the four programs will often start one of the other Curve Following contours and not the associated one (according to the Settings).
My customer might not like it if I put the project public here. Is there a way I can send it to you?
Best regards,
Emile