Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RoboDK post processor for KUKA robot using KR C5.

#5
(01-13-2022,08:20 PM)Jeremy Wrote:Two things,

You should add an ID at the end of your frame name: Ceiling Frame 2

Exporting the name of the target is not supported with this post processor.

I will try to add this feature in the next release of RoboDK.

Jeremy

Hi Jeremy.

Thanks for your reply. First of all, I wondered why I did not get a notification of your reply. :)

But what do you mean with adding a ID at the end of the frame :" Ceiling Frame 2" ?

(01-17-2022, 10:09 AM)christian.hansen Wrote:
(01-13-2022,08:20 PM)Jeremy Wrote:Two things,

You should add an ID at the end of your frame name: Ceiling Frame 2

Exporting the name of the target is not supported with this post processor.

I will try to add this feature in the next release of RoboDK.

Jeremy

Hi Jeremy.

Thanks for your reply. First of all, I wondered why I did not get a notification of your reply. :) Update: I saw that I could "subscribe" to this thread. I have done that now.

But what do you mean with adding a ID at the end of the frame :" Ceiling Frame 2" ?


Messages In This Thread
RE: RoboDK post processor for KUKA robot using KR C5. - bychristian.hansen- 01-17-2022, 10:09 AM



Users browsing this thread:
1 Guest(s)