Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Universal Robots: moveL / moveP command

#5
Hi, I am trying to use the MoveP post processor, but if so the robot stops the programm after 1 sek. With the general Universal Robot post processor everythings is fine but the curves are executed quite poorly. The robot shivers constantly.

Can somebody help?

Best regards


Messages In This Thread
RE: Universal Robots: moveL / moveP command - byLara- 12-10-2021, 02:02点



Users browsing this thread:
2 Guest(s)