Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Post Processor

#1
Hi
When running a program through a post processor, how do I determine the name of the current target within the MoveJ section of the post processor?
I'm using the joints to add a joint command but want to change a parameter based on the name of the target within RDK
问候


Messages In This Thread
Post Processor - byANDY_F1- 12-06-2021, 04:29 PM
再保险:后置处理程序 - byJeremy- 12-06-2021, 10:36 PM
再保险:后置处理程序 - byANDY_F1- 12-06-2021, 11:08 PM
再保险:后置处理程序 - byJeremy- 12-07-2021, 02:15 AM
再保险:后置处理程序 - byANDY_F1- 12-11-2021, 02:30 PM
再保险:后置处理程序 - byJeremy- 12-15-2021, 09:08 PM
再保险:后置处理程序 - byANDY_F1- 12-20-2021, 05:02 PM
再保险:后置处理程序 - byAlbert- 12-20-2021, 07:37 PM



Users browsing this thread:
1 Guest(s)