RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Layer Heights from Slic3r are not generating correctly
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Layer Heights from Slic3r are not generating correctly

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Layer Heights from Slic3r are not generating correctly
DorisBoris Offline
Member
**
Posts: 10
Threads: 3
Joined: May 2020
Reputation: 0
#3
11-05-2021, 12:49 PM
Hey

你找到这个解决方案吗?

I have not succeeded either on increasing layer height above 1 mm.

Is there some way to increase layer height up to 5 mm < or is this not possible with Slic3r?
Find
Reply


Messages In This Thread
RE: Layer Heights from Slic3r are not generating correctly - byDorisBoris- 11-05-2021, 12:49 PM



Users browsing this thread:
1 Guest(s)