10-29-2021, 03:45 PM
(This post was last modified: 10-29-2021, 03:46 PM byJUNYAIWASAKI.)
Hello, nice to meet you.
My name is Iwasaki.
This time, I purchased a robot arm and RoboDK to use in my work.
I have a Kawasaki Heavy Industries "FS45N". The controller side of the robot arm has a RS232 connector, but no Ethernet interface.
When I try to connect to the RoboDK system via RS232, I get a connection error.
I cannot connect the robot arm to the RoboDK even after following the instructions on the support site.
Reference site (2022世界杯32强赛程表时间 )
What can I do to solve this problem?
I am very confused.
I would appreciate your advice.
My name is Iwasaki.
This time, I purchased a robot arm and RoboDK to use in my work.
I have a Kawasaki Heavy Industries "FS45N". The controller side of the robot arm has a RS232 connector, but no Ethernet interface.
When I try to connect to the RoboDK system via RS232, I get a connection error.
I cannot connect the robot arm to the RoboDK even after following the instructions on the support site.
Reference site (2022世界杯32强赛程表时间 )
What can I do to solve this problem?
I am very confused.
I would appreciate your advice.