10-25-2021, 08:29 AM
(This post was last modified: 10-25-2021, 08:30 AM byHikaru Kamio.)
(10-19-2021, 04:48 PM)Albert Wrote:@Phillipjust fixed your Mitsubishi driver issues and we published a new update today that contains the latest version of the Mitsubishi driver and post processor (Windows 64 bit version only). Let us know if you still have issues with the latest version.
Thank you phillip. Liner and circllar motions are now possible. Bun I still have some problems.
1. I can't slow down robot speed at "setSpeed"
Even if the value of "setSpeed" is less than 50, the error disappears, but the speed of the actual machine does not become less than 50 (I was able to make it less than 50 only at the beginning, but now it is 50 no matter how much I lower the value will not bebelow)
2. I can't upload the program to the robot
When I tried to upload a program to the robot to make it run smoothly, I coudn't. When I try to upload Prog1 of the attached program (test10) , I get error like the 1st to 3rd photos, and when I try to upload Prog10, I get error like the 4th to 5th photos.
Can these issues be resolved with the current version? if possible, please teach me how to do it.