10-09-2021, 10:56 PM
Hello @Oliver @Albert
I have figured out most of my issues with programming and moving and had a few successful prints. I am now trying to program a part that has ~200 curves and I am running into the screen using a "clipping plane" and cutting off parts of my setup. I have my setting set up for best performance under the display. I have a 24 core processor and an RTX 3080 TI graphics card, I should not be limited on my computer side. Do you have any suggestions? I have tried turning off my extruder, table, and robot to see if trying to process would be easier and it hasn't helped.
Best,
Austen
I have figured out most of my issues with programming and moving and had a few successful prints. I am now trying to program a part that has ~200 curves and I am running into the screen using a "clipping plane" and cutting off parts of my setup. I have my setting set up for best performance under the display. I have a 24 core processor and an RTX 3080 TI graphics card, I should not be limited on my computer side. Do you have any suggestions? I have tried turning off my extruder, table, and robot to see if trying to process would be easier and it hasn't helped.
Best,
Austen