09-23-2021, 06:52 PM
(This post was last modified: 09-23-2021, 07:34 PM byAdegrenier1.)
I have two problems currently with my project.
1) Angled Lines file- I am looking to have the tool head be perpendicular to the tool path. I have tried various settings, and I can't seem to find a solution. I'm sure there is a simple solution, but I can't seem to find it.
2) Rhino and curves... Robodk segments the curves, and I find my robot accelerating and decelerating at every node. Is there a simple way to bring either curves into Robodk and use the circular movement command, or are there other options?
I would love to have tech support... Is there a way to have one-on-one support with someone, even if there is a rate?
See attached
1) Angled Lines file- I am looking to have the tool head be perpendicular to the tool path. I have tried various settings, and I can't seem to find a solution. I'm sure there is a simple solution, but I can't seem to find it.
2) Rhino and curves... Robodk segments the curves, and I find my robot accelerating and decelerating at every node. Is there a simple way to bring either curves into Robodk and use the circular movement command, or are there other options?
I would love to have tech support... Is there a way to have one-on-one support with someone, even if there is a rate?
See attached