Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

首先PTP移动位置

#3
I have done the milling toolpath in Fusion 360 and I get a .tap file from there. Then I make the robot program in RoboDK using Robot Machining Project and select the NC file in Path input.

It´s possible to check the real robot position and modify the first PTP motion joint values manually after code generation but it`s not really effective.


Messages In This Thread
首先PTP移动位置 - byophakala- 09-22-2021, 11:01 AM
RE: First PTP move position - byOlivier- 09-22-2021, 03:50 PM
RE: First PTP move position - byophakala- 09-23-2021, 07:25 AM
RE: First PTP move position - byOlivier- 09-23-2021, 06:17 PM
RE: First PTP move position - byophakala- 09-29-2021, 07:49 AM



Users browsing this thread:
1 Guest(s)