03-05-2019, 02:17 PM
Hi Mario,
You are right. There was a small bug with our default Nachi post processor when generating circular movements (G-codes G02 and G03).
I attached an updated post processor to fix this. To solve the problem you should place the attached file here:
C:/RoboDK/Posts/
And re-generate the program.
This post will be added by default with our future updates.
Albert
You are right. There was a small bug with our default Nachi post processor when generating circular movements (G-codes G02 and G03).
I attached an updated post processor to fix this. To solve the problem you should place the attached file here:
C:/RoboDK/Posts/
And re-generate the program.
This post will be added by default with our future updates.
Albert