Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

milling problem

#1
Good afternoon.

今天我买了学生许可,当我发送a shit track from the fusion 360 program to the robodk it also shows up but when I want to generate a program from it that I can then use on the robot then I can't generate a program.

I will also send the program and the error message.
Thank you in advance for your reply.


Attached Files Thumbnail(s)


.rdk milling.rdk(Size: 1.59 MB / Downloads: 235)
#2
Hello,

I am sending you the Post Processor in reply to email you sent me. You need to paste the PP in the Posts folder under C:\RoboDK\Posts
It should work then.




Users browsing this thread:
1 Guest(s)