Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

FANUC Run on Robot Issue

#1
Hello,

I'm having a problem with the Run on Robot feature with my Fanuc LR Mate 200iD/7L robot (I'm using the V9 driver). I can properly connect and get joint positions, and I've created a simple program to just move the robot slightly to test it, which properly shows movement in RoboDk simulation. However, when I attempt to run on the robot, I see INTP-265 on my touch pendant. I saw in another post that the issue is likely improper values for registers 50 and 51 and maybe 53. When I checked the values they were set to 100, -1, and 0 respectively so I changed R[50] and R[51] to 20 and 100. This made no change, as it seems every time I try to run the program it changes the values back to 100 and -1. I then tried also changing R[53] to 100 and this prevented the INTP-265 error but the robot still did not move. I also tried adding a speed command to my program but the register values still reverted to the old ones. Any advice on this?
#2
Hi Azabaldo,

Did you follow these steps and instructions to set up the Fanuc driver?

//www.sinclairbody.com/doc/en/Robots-Fanuc.html#DriverFanuc

Jeremy
Find useful information about RoboDK and its features by visiting our2022世界杯32强赛程表时间 and by watching tutorials on ourYoutube Channel.


#3
Hi Jeremy,

Yes I did. I'm able to confirm the connection and get the joint positions, just not move the robot. Are any of the other sections required to complete or just the Fanuc Driver section?
#4
Hi Azabaldo,

What version of RoboDK are you using? (Help->About)

Jeremy
Find useful information about RoboDK and its features by visiting our2022世界杯32强赛程表时间 and by watching tutorials on ourYoutube Channel.


#5
RoboDK v5.2.1 (64 bit)
#6
Any updates on this?
#7
Can you update RoboDK to the latest version?

The latest version has been published today (RoboDK v5.2.2).

If you still have issues it would help if you can send us a screenshot of the log window of your driver.
#8
I believe it is now working! Either the new software release or pulling a newer version of the driver fixed it. Thank you!




Users browsing this thread:
1 Guest(s)