Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Fanuc Program Memory issue ( driver install for fanuc robot )

#1
Hello,

I don't have enough memory on a FANUC 120iC robot and was thinking would this option be able to run larger programs as it wouldn't be limited to the memory on the controller?

Right now, I have to break programing into multiple files for 3D printing before uploading them into the controller with the upload option.

Thanks,

Andrew
#2
You can use the Fanuc Dripfeed postprocessor

This will Generate a drip feeder program that will split long programs in subprograms and load them to the controller as they are executed

The dripfeed post-processor will create a Python file, most likely in "C:\Users\xxx\Documents\RoboDK".
You can then run this .py file to start the dripfeed.

Prior to generating the program, you also need to properly set the controller IP address in RoboDK.
1. Right-click a robot
2. Select "Connect to robot…"
3. Enter the IP of the robot

You also need to make sure the FTP server is properly set on the controller side:
//www.sinclairbody.com/doc/en/Robots-Fanuc.html#FTP-Fanuc




Users browsing this thread:
1 Guest(s)