Staubli VAL3 Postprocessor- Printable Version +- RoboDK Forum (//www.sinclairbody.com/forum) +-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN) + - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK) +--- Thread: Staubli VAL3 Postprocessor (/Thread-Staubli-VAL3-Postprocessor) |
Staubli VAL3 Postprocessor-mzacri-08-02-2022 Hi, The Staubli's VAL3 postprocessor generate code in the s7.X.X version of VAL3. Is there a way to downgrade this version to s5.5 since this is the newest version i can use on my CS8 controller? Thanks! 再保险:年代taubli VAL3 Postprocessor-Sam-08-03-2022 We have post-processors for S6 and S7. You can request a new post-processor at info@www.sinclairbody.com. 再保险:年代taubli VAL3 Postprocessor-mzacri-08-04-2022 (08-02-2022, 03:35 PM)mzacri Wrote:Hi, Thanks a lot. I suppose because of the version mismatch, i was able to connect to robot, get its current position but i was not able to move it from RobotDK. |