+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: Connection problems between RoboDK and NX100 motoman controller (/Thread-Connection-problems-between-RoboDK-and-NX100-motoman-controller)
Connection problems between RoboDK and NX100 motoman controller-lehoanganhtai-03-23-2022
Hi,
I'm having some problems connecting RoboDK to NX100 Motoman controller.I have followed all the steps in here//www.sinclairbody.com/doc/en/Robot-Drivers.html#DriverTroubleshoot,//www.sinclairbody.com/doc/en/Robots-Motoman.htmland made a ping test. The communication between my computer and the controller was successfully done. However, I still couldn't connect and didn't figure out a way to fix it while I succeeded in connecting RoboDK with DX100 and YRC1000 controllers. Can you guys suggest to me some solutions for these problems?
Thanks.
RE: Connection problems between RoboDK and NX100 motoman controller-Mihail-11-09-2022
Hi lehoanganhtai,
Did you found the solution for this problem?
We are dealing with the same issue with two Motoman controllers(DX100 and NX100).
Kind regards,
Mihail
RE: Connection problems between RoboDK and NX100 motoman controller-Albert-11-10-2022
Did you place the robot in Remote mode? This is a switch in the teach pendant.
Right after you connect, does it work if you select Get Position in the connection panel?
RE: Connection problems between RoboDK and NX100 motoman controller-Mihail-11-15-2022
Hello Albert,
Yes I have tried it with the teach pendant in "Remote Control" mode.
And I also have tried the buttons "Get Position", "Move Joints" and "Stop"... and in the log file I am getting always "connection problems"