+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+--- Forum: General questions about RoboDK (//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: Fanuc Program Memory issue ( driver install for fanuc robot ) (/Thread-Fanuc-Program-Memory-issue-driver-install-for-fanuc-robot)
Fanuc Program Memory issue ( driver install for fanuc robot )-AKL-03-21-2022
Hello,
I don't have enough memory on a FANUC 120iC robot and was thinking would this option be able to run larger programs as it wouldn't be limited to the memory on the controller?
Right now, I have to break programing into multiple files for 3D printing before uploading them into the controller with the upload option.
Thanks,
Andrew
RE: Fanuc Program Memory issue ( driver install for fanuc robot )-Alex-03-22-2022
You can use the Fanuc Dripfeed postprocessor
This will Generate a drip feeder program that will split long programs in subprograms and load them to the controller as they are executed
The dripfeed post-processor will create a Python file, most likely in "C:\Users\xxx\Documents\RoboDK".
You can then run this .py file to start the dripfeed.
生成程序之前,您还需要properly set the controller IP address in RoboDK.
1. Right-click a robot
2. Select "Connect to robot…"
3. Enter the IP of the robot
You also need to make sure the FTP server is properly set on the controller side:
//www.sinclairbody.com/doc/en/Robots-Fanuc.html#FTP-Fanuc