+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: RDK Remote Connection to UR10e - Waiting status (/Thread-RDK-Remote-Connection-to-UR10e-Waiting-status)
RDK Remote Connection to UR10e - Waiting status-ssansoy-12-03-2021
We are trying to remotely control a UR10e cobot thru RoboDK, using theConnect to robot...option
in the popup window we type the IP in theRobot IP/COMfield and can successfully ping the robot.
When we try to connect (on both mac and windows), we get aConnection status: Waiting...
Pressing Show log reveals the following
Server established: 192.168.90.128:30002
Connected to 192.168.90.128:30002. Sending program :/progrobodk.script...
Updating computer IP on program: 192.168.90.130
Updating computer port on program: 30000
Program sent.
Waiting...
On both mac and windows boxes we have assigned a static ips and have firewalls turned off on both.
but we cant run any programs. its just stuck.
Any help would be awesomely appreciated.
Sabri
RE: RDK Remote Connection to UR10e - Waiting status-Jeremy-12-06-2021
Did you make sure the robot was in "Remote control" mode and that the driver is actually running on the controller? (A program should be sent automatically to the controller by RDK and it must run).
Jeremy
RE: RDK Remote Connection to UR10e - Waiting status-ziga004-02-25-2022
Hi!
As per other reply, yes, you need to make sure that you have your robot in Remote Control, that the Ethernet card is enabled, remote option is turned On in settings, and that you have an exception in your firewall for apiur.exe. After the connection gives a green ready, you can disable Remote Control to Local Control once again and the connection will remain.
Also, make sure you've set the correct static IP on the robot. Use the same IP as your computers, but change the last number.
Cheers