+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ -论坛:通用电气neral questions about RoboDK (//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: Layer Heights from Slic3r are not generating correctly (/Thread-Layer-Heights-from-Slic3r-are-not-generating-correctly)
Layer Heights from Slic3r are not generating correctly-macroktg-04-27-2021
Hi,
Having some issues with the layer heights that Slic3r is generating for me. I set to 50mm and it seems to only generate 1 layer at that size and then the rest back to 1mm. Is there some other settings that need to be changed? Or another way to ensure my objects are sliced correctly?
Thanks
RE: Layer Heights from Slic3r are not generating correctly-Jeremy-04-27-2021
Did you look at Slic3r documentation?
I'm pretty sure I was able to controller each layer thickness. The first one is generally independent of the others.
RE: Layer Heights from Slic3r are not generating correctly-DorisBoris-11-05-2021
Hey
你找到这个解决方案吗?
I have not succeeded either on increasing layer height above 1 mm.
Is there some way to increase layer height up to 5 mm < or is this not possible with Slic3r?
RE: Layer Heights from Slic3r are not generating correctly-Albert-11-05-2021
The layer height can't be greater than your extruder diameter. I recommend you to increase the size of your extruder before increasing the layer height.
Robot 3D printing usually requires larger values for these 2 variables (compared to desktop 3D printers).
RE: Layer Heights from Slic3r are not generating correctly-DorisBoris-11-05-2021
(11-05-2021, 01:56 PM)Albert Wrote:The layer height can't be greater than your extruder diameter. I recommend you to increase the size of your extruder before increasing the layer height.
Robot 3D printing usually requires larger values for these 2 variables (compared to desktop 3D printers).
Thank you for your fast answer Albert!
I have increased also the diameter of the extruder and tried several other parameters as well.
Have you been able to increase the layer hight and export g-codes with more than 1 mm layer hight from Slic3r? Is there maby other things I haven't realized?