Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
etherCAT support
#1
Are there plans to support connecting to the live robots over the etherCAT protocol?

Some tasks ( like glue dispensing ) will require hard real-time support.
#2
Ethercat is one of the many protocols supported by robot controllers. If you need real time support it may be better to use vendor-specific protocols. For example, for Fanuc it would be PCDK, for KUKA it would be RSI, for Motoman it would be Motocom. These protocols are usually based on TCP/IP or UDP.

Except for most collaborative robots (such as Universal Robots), these are usually paid software options that need to be purchased from robot vendors.




Users browsing this thread:
1 Guest(s)