Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Workspace display settings

#1
Are there any settings for the workspace and how it is displayed around the robot? I have a Kuka KR 120 R3200 PA robot that I have inserted into a model. When I go to turn on the workspace. I set it to Show for Robot Flange, but I only small gray sphere's all around the robot at the places where the lines would normally show up . Are there any settings to allow it to show the full robot reference grid?

Thanks,
Isaac Spencer


Attached Files Thumbnail(s)


.robot KUKA-KR-180-2-PA.robot(Size: 968.61 KB / Downloads: 122)
#2
This is a palletizing robot (4 axis robot) and RoboDK is unable to show the sphere you usually see with 6-axis robot arms.

On the other hand, you could use the Reachability app to check the reachability at certain points:
  1. SelectTools-Plug Ins
  2. Make sure theAppLoader启用插件(双击)
  3. SelectTools-Apps List
  4. Double click on theReachabilityapp (or make sure it is enabled)
  5. You'll see theReachabilitymenu and you can selectReachability-Check reachability
You should then see how reachable the current position is with the active tool. Make sure you have a tool active.




Users browsing this thread:
1 Guest(s)