Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

FANUC I/O

#1
Question
Hello! I am having trouble using the setDO command on robodk, and was unable to understand fully what the solutions were on other similar threads. Simply running that i/o command with a number as the name, and 1 as the value, had no visible effect on the robot's teach pendant. Any help with what code to write in, or any other suggestions would be greatly appreciated!

Thank you,

Jeremiah~Millersville Robotics
#2
Are you controlling the robot using a Driver or using a Post Processor to generate a program to later load into your controller?
#3
(04-15-2022, 03:36 AM)Alex Wrote:Are you controlling the robot using a Driver or using a Post Processor to generate a program to later load into your controller?

I am controlling the robot through the use of a driver.




Users browsing this thread:
1 Guest(s)