[mzacri]

Hi,

The Staubli's VAL3 postprocessor generate code in the s7.X.X version of VAL3. Is there a way to downgrade this version to s5.5 since this is the newest version i can use on my CS8 controller?

Thanks!

[Sam]

We have post-processors for S6 and S7.

You can request a new post-processor at info@www.sinclairbody.com.

[mzacri]

Hi,

The Staubli's VAL3 postprocessor generate code in the s7.X.X version of VAL3. Is there a way to downgrade this version to s5.5 since this is the newest version i can use on my CS8 controller?

Thanks!

Thanks a lot. I suppose because of the version mismatch, i was able to connect to robot, get its current position but i was not able to move it from RobotDK.