[cotega]

Hi,

We successfully used the Leica Laser Trackers API for automated robot calibration (the input is XYZ 3D data). I would like to know it the API allows to use a Leica AT960 equipped with a T-MAC for 6D data acquisition.

Thanks,

Gabriel

[Albert]

Yes, RoboDK supports taking 6D measurements using the Leica T-Mac probe. You can take 3D and 6D measurements.

Make sure to select pose measurements (6D) when you start a new calibration project in RoboDK.

[Jon Eguskiza]

Yes, RoboDK supports taking 6D measurements using the Leica T-Mac probe. You can take 3D and 6D measurements.

Make sure to select pose measurements (6D) when you start a new calibration project in RoboDK.

Do you need to command something especial to select the "reflector" that will be the T-MAC?

---

Yes, RoboDK supports taking 6D measurements using the Leica T-Mac probe. You can take 3D and 6D measurements.

Make sure to select pose measurements (6D) when you start a new calibration project in RoboDK.

Do you need to command something especial to select the "reflector" that will be the T-MAC?

[Albert]

Yes, you should use the Command button to set the correct target (SETR command). You can see in the log the targets that were found and the default commands are updated accordingly. If you can send us a print screen of the log after connecting to the tracker and the predefined Commands we can help you better.