01-06-2022, 02:04 PM
Hello Patrick!
Thank you very butch for sharing your workflow anf scripts for CS8 controller.
我有类似的模型(CS8C TX60机器人),can not deal with MoveL commands and RunOnRobot mode at same time. The MoveL working good while I upload to robot, but when I run on robot, gives me an error (soflimit reached). The MoveJ command just working good.
How did you deal with this situation? I tried all posts and I have installed HSM Machining on SC8C so I tried the machining post as well. All of them working the same - giving me fault at MoveL.
Bests,
Eduard
Thank you very butch for sharing your workflow anf scripts for CS8 controller.
我有类似的模型(CS8C TX60机器人),can not deal with MoveL commands and RunOnRobot mode at same time. The MoveL working good while I upload to robot, but when I run on robot, gives me an error (soflimit reached). The MoveJ command just working good.
How did you deal with this situation? I tried all posts and I have installed HSM Machining on SC8C so I tried the machining post as well. All of them working the same - giving me fault at MoveL.
Bests,
Eduard