[Gordax]

HI,

Is there a way to only use linear movements not circular moves? I have tried to reduce the length of the circular movements but I am getting very inaccurate results with curves and I am trying to nut it out. My robot does not use circular moves and it does straight lines very well.

似乎我也不能to be able to tell the DXF2GCode to start at a particular spot, I can set start from nearest but then it over that position and starts where it thinks id better. I am trying to make lead in's .

Thanks

[Albert]

To convert circular movements to small linear movements when you generate your robot program you can change the following settings:

1. Select Tools-Options-Program tab
   
2. Set Minimum arc size (mm) to 1 mm
   
3. Set Maximum arc size (mm) to 1 mm
   

See attached image: